How to Press DTF Transfers

How to Press DTF Transfers

Pressing DTF (Direct-to-Film) transfers is a straightforward process, but it requires attention to detail to achieve the best results. Here’s a step-by-step guide:

What You'll Need

  1. A heat press machine
  2. The garment (T-shirt, hoodie, etc.)
  3. DTF transfer film with the design
  4. Protective sheet (e.g., parchment paper or Teflon sheet)

Steps to Press DTF Transfers

  1. Preheat the Heat Press

    • Set your heat press to the required temperature and time based on the DTF transfer instructions.
    • Typical settings:
      • Temperature: 300–325°F (150–165°C)
      • Time: 10–15 seconds
      • Pressure: Medium to high

  2. Prepare the Garment

    • Place the garment on the heat press platen, ensuring it lies flat and smooth (no wrinkles or folds).
    • Use the heat press to preheat the garment for 2–5 seconds. This removes moisture and wrinkles, providing a better surface for adhesion.

  3. Position the DTF Transfer

    • Place the DTF transfer film ink-side down on the garment.
    • Align the design to the desired position. Use a ruler or alignment tool if needed for accuracy.

  4. Cover with a Protective Sheet

    • Place a Teflon sheet, parchment paper, or silicone sheet over the transfer to protect it during pressing.

  5. Press the Design

    • Close the heat press and apply heat, pressure, and time according to the recommended settings.
    • Ensure the press is evenly distributing pressure over the entire design.

  6. Cool Peel or Hot Peel (Depending on Film Type)

    • Once the pressing is complete, carefully remove the garment from the press.
    • Check whether the transfer requires a hot peel (remove the film immediately) or a cold peel (wait for the transfer to cool before peeling).
    • Peel the PET film slowly and evenly to avoid damaging the design.

  7. Optional Post-Press

    • For enhanced durability and a softer feel, place a Teflon sheet over the design and press it again for 5–10 seconds at the same temperature.

Pro Tips for Perfect Results

  • Pressure Matters: Ensure the pressure is neither too light nor too heavy for even transfer.
  • Check Instructions: Different DTF films may require slightly different temperatures and times.
  • Garment Care: Let the garment cool before folding or wearing. Wash it inside out after 24 hours for durability.

By following these steps, you’ll achieve vibrant, durable, and professional-quality transfers every time!

Back to blog