How to Press DTF Transfers

Pressing DTF (Direct-to-Film) transfers is a straightforward process, but it requires attention to detail to achieve the best results. Here’s a step-by-step guide:

What You'll Need

1. A heat press machine
2. The garment (T-shirt, hoodie, etc.)
3. DTF transfer film with the design
4. Protective sheet (e.g., parchment paper or Teflon sheet)

Steps to Press DTF Transfers

1. Preheat the Heat Press

   • Set your heat press to the required temperature and time based on the DTF transfer instructions.
   • Typical settings:
     • Temperature: 330°F
     • Time: 15 seconds
     • Pressure: Firm pressure

2. Prepare the Garment

   • Place the garment on the heat press platen, ensuring it lies flat and smooth (no wrinkles or folds).
   • Use the heat press to preheat the garment for 2–5 seconds. This removes moisture and wrinkles, providing a better surface for adhesion.

3. Position the DTF Transfer

   • Place the DTF transfer film ink-side down on the garment.
   • Align the design to the desired position. Use a ruler or alignment tool if needed for accuracy.

4. Cover with a Protective Sheet

   • Place a Teflon sheet, parchment paper, or silicone sheet over the transfer to protect it during pressing.

5. Press the Design

   • Close the heat press and apply heat, pressure, and time according to the recommended settings.
   • Ensure the press is evenly distributing pressure over the entire design.

6. Hot Peel

   • Once pressing is complete, carefully remove the garment from the press.
     
   • DTF transfers should be peeled hot, meaning the film must be removed immediately while still hot.
     

   • Hold the garment firmly with one hand and use the other hand to peel the PET film quickly in one motion for best results.

     
     

7. Optional Post-Press

   • For enhanced durability and a softer feel, place a Teflon sheet over the design and press it again for 5–10 seconds at the same temperature.

Pro Tips for Perfect Results

• Pressure Matters: Ensure the pressure is neither too light nor too heavy for even transfer.
• Check Instructions: Different DTF films may require slightly different temperatures and times.
• Garment Care: Let the garment cool before folding or wearing. Wash inside out with cold water on a gentle cycle after 24 hours for durability. Avoid bleach or fabric softener. Tumble dry low or hang to dry. Don’t iron directly on the design. 

By following these steps, you’ll achieve vibrant, durable, and professional-quality transfers every time!